Rudder part 2

... placed the HD inserts ( actually should have put them before tracing to avoid having to retrace the lines over the inserts)

Then started rounting form the edges in to keep the next lines always visible.

.... some preliminary sanding and the foil starts to show up.

On the other side I used 2mm steps. It's quicker and produces the same effect.

On both sides I left the contour isometrics for hand shaping since it's a lot easier and less confusing.

Finaly I cut the foil off and did some sanding.

Tomorrow I expect to finish final shaping and leave it ready for lamination.

I missed the little insert for the rope. I'll add it in later on using an HD putty fill or a piece of G10 tube with plastic bushings.

This process although time consuming is pretty straight forward and reasonably precise.

The HD core can now be cut and wraped with glass according to plans.